Page
23
of
36
The graphical procedure for entering the access code, allowing entry into the settings and
programming mode is shown below:
6.5. Description of the purpose of the buttons when setting/editing.
– entering the setting mode
– confirmation of changes made (without it no changes will be saved)
– going back to the previous status (without saving changes)
– exiting the setting mode; it may be necessary to press this button several times
(depending on where the change was made)
– move from right to left on the display - to edit the duration of the step
– switching between diodes - to determine the relay status (signaled by a diode)
– entering the settings related to temperature functions (MCH-07T version only)
– program selection
– selection of parameter (function) to be edited
– selection of step (sequence) to be edited
– editing the duration of the step
– relay activation (diode lights up)
– selection of program
– selection of parameter (function) to be edited
– selection of step (sequence) to be edited
– editing the duration of the step
– relay deactivation (diode is off)
flashing digit / diode – indication of readiness for editing
30 sec. of inactivity – exiting the setting mode without any changes saved
