Makita XMT04, Instruction Manual

Page: 10 / 24

10 ENGLISH
Apply a sanding paper on the workpiece.
NOTE: Before the operation, it is recommended to
determine a suitable orbital stroke rate by sanding a
test material sample as trial.
NOTE: It is recommended not to change the grid of
the sanding paper until you finish sanding the whole
surface of the workpiece. Changing the grid of the
sanding paper on the half way may cause an unfine
finish.
Dust attachment for sanding
operation
Optional accessory
CAUTION:
Do not use the dust extraction
attachment when sanding metal. Sucking spark
and hot particle results in smoking and ignition.
Installing the dust attachment
1. Remove the holder bolt and the application tool.
2. Put the dust attachment with the latches aligned
with the notches on the tool.
Slide the dust attachment as shown in the illustration.
1
2
3
►
1. Dust attachment 2. Latch 3. Notch
3. Install the sanding pad and the holder bolt.
4. Connect the hose of the vacuum cleaner to the
dust extraction attachment.
Removing the dust attachment
1. When removing the dust attachment, remove the
holder bolt and the sanding pad.
2. Slide the dust attachment while opening the
latches by hands as shown in the illustration, and then
remove the dust attachment from the tool.
1
1
►
1. Latch
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.