| 70 |
EN
3.4 Machine parts and controls
(See Figure
1
)
1 ON / OFF switch
2 Handle
3 Rear roller
4 Nozzle for dust extractor hose connection
5 Rotation direction arrow
6 Washer
7 Hexagonal screw (left-hand thread)
8 Diamond dry-cutting disc
9 Protective hood
10 Front roller
11 Front handle
12 Green LED
13 Red LED
Working direction
3.5 Intended use
The diamond cutters listed in this instruction manual
are only approved for dry cutting in masonry (brick,
lime-sand blocks, undressed stone) and concrete.
They must not be used for wet cutting or for cuts in
metal, glass, wood, etc.
•
Observe the relevant regulations in your
country for the materials to be machined.
•
The diamond cutters are only approved for use
together with a dust extractor, which is suitable
for stone dust (e.g. MAKITA Special Dust
Extractor).
wARNING
Risk of injury due to cracking and breaking of
the diamond dry-cutting disc (bits of disc flying
around).
Î
Diamond dry-cutting discs are designed for
straight
cuts.
If used to cut curves the diamond dry-cutting
disc becomes deformed which causes internal
cracks and segments to break off.
•
Do not expose diamond dry-cutting discs to
lateral pressure.
•
Never use diamond dry-cutting discs for rough
grinding.
3.2 eC Declaration of Conformity
Makita declares that the following
Machine(s):
Designation of Machine: Diamond Cutter
Model No. / Type: SG150, SG180
Conforms to the following
european Directives:
2006 / 42 / EC
2014 / 30 / EC
2011 / 65 / EC
They are manufactured in accordance with
the following standard or standardized
documents:
EN60745
The Technical file in accordance with
2006 / 42 / EC is available from:
Makita,
Jan-Baptist Vinkstraat 2, 3070, Belgium
02.02.2015
Yasushi Fukaya
Director
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3.3 Machine characteristics
The machines are equipped with specially
developed electronics. It monitors the speed and
the green / red indicator lights (items 13 and 14,
see Figure
1
) help to achieve the most favourable
work progress and therefore tool-protecting working
conditions.
Visual display
Green: Speed for optimum cutting performance
Red:
Speed too low – stopping
If this warning signal is ignored, i.e. the feed is not
reduced, the electronics switch off on overload.
After the diamond dry-cutting discs have stopped,
remove them from the chase. The machine can be
restarted immediately.
