Hood section
V belt 5-800
Cutting device
[4] DISASSEMBLY/ASSEMBLY
[4]-1. V-belt 5-800, Cutting device
R
epair
P
4
/
19
(1) Loosen two M8 Hex nuts slightly with Wrench 13-16 of a standard accessory. (
Fig. 2
)
(2) Release the tension on V-belt 5-800 by turning M6 Tensioning screw counterclockwise with Screwdriver.
The position of M6 square nut shows the tension level; as it comes close to the minus mark, the belt tension is
relieved. (
Fig. 2
)
(3) When Water supply set is on the machine, remove it. (
Fig. 3
)
Holder (
Fig. 2
) can be removed from Belt cover by turning clockwise/ counterclockwise to 90° .
(4) Remove two M8 Hex nuts, then separate Belt cover and Hood section from the machine. (
Fig. 4
)
(5) When Hood section is disassembled:
1. Face the blade installation side of Spindle toward the ram of Arbor press.
2. Press Spindle out of Cutting device. Ball bearing 6203LLU is removed together with Spindle. (
Fig. 5
)
(6) Remove Retaining ring R-40 from Cutting device with 1R291, and then press the other 6203LLU out of
Cutting device. (
Fig. 6
)
Fig. 2
Fig. 3
Fig. 5
Fig. 6
Fig. 4
M8 Hex nut (2 pcs.)
Minus mark
M8 Hex nut
(2 pcs.)
M6 Square nut
Cutting device
Note
: Another Ball bearing 6203LLU
and Retaining ring R-40 are left
in Cutting device as drawn
in
Fig. 6
.
Cutting device viewed
from Belt cover side
Arbor press
Spindle
One of Ball bearing 6203LLU
Ball bearing
6203LLU
Retaining ring R-40
M6 Tension screw
Belt cover
Belt cover
Water supply set
DISASSEMBLING
Holder