28
5.2.4
Advanced setup
1.
Nozzle diameter:
0.4 This value is currently fixed. Reverse speed: The speed of
reverse pumping.
Effect:
Theoretically, it will be better if it is faster, but it may cause no filament.
2.
Inverted length:
The length of the reversed withdrawal wire. These two parameters
are the basic settings, by default, reverse pumping is allowed.
Effect:
If the length of the reverse withdrawal wire is too short, it may cause wire
drawing. If it is too long, may not produce filament.
3.
Initial layer height:
The first layer thickness.
Effect:
The first layer is set thicker to allow the model to stick tighter.
4.
Cut off the bottom:
When some models are uneven at the bottom, or when there are
few contact surfaces, you can cut off part of it.
Effect:
For models that are not very important at the bottom or need to be printed
separately, you can set the cut a certain height to print, the effect will be better.
5.
Double-headed overlap:
Double-headed printers need to be set for printing, and
repeats the amount of squeezing when setting the double-headed printing.
Effect:
Set a certain amount of repetitive extrusion, can make two colors stick tighter.
6.
Movement speed:
The speed of machine movement.
Effect:
The faster the movement speed, the shorter the printing time.
7.
Underlying print speed:
The speed of printing the bottom layer, low speed can stick
more tightly.
Effect:
The lower printing speed of the bottom layer can be adjusted to make the
bottom stick more tightly so that it can be printed better.
8.
Fill Speed:
The speed at which the fill is printed.
Effect:
Accelerate the fill speed and you can print faster.
9.
Outer wall speed:
Print the speed of the outer wall, low speed printing can make the
outer wall print better.
Effect:
Decrease the printing speed of the outer wall can make the surface smoother.
10.
Inner wall speed:
prints the speed of the inner wall. Speed up can shorten the
printing time.
Effect:
Accelerate the print speed of the inner wall and shorten the printing time.
