26
5.2
Introduction to the application of slicing software
5.2.1
Fast print
（
Not recommended for use
）
Click
”Experts configuration”
- switch to
“Fast print mode”
Fast print: No need for users to set
parameters themselves, all parameters
will be set to the corresponding default
value as required.
The options in the diagram include
printing patterns, materials, and whether it is
supported.
5.2.2
Full mode printing
Click
expert configuration
-
switch to
full mode
- select
“Yes”.
You can see the full pattern with various
parameters, and see the details of each
parameter by mousing over the options for
the parameters.
The printed parameters can be set
according to the displayed information as a
reference.
5.2.3
Basic setup
1.
Layer thickness:
The thickness of each layer filament supports 0.05-0.3, and it is
recommended to take value between 0.1-0.2.
Effect:
The smaller the layer thickness, the finer the surface, the longer the printing
time.
2.
Wall thickness:
The outer wall thickness of the model is 0.4 per layer filament, and it
is recommended to take values between 0.8 and 2.0.
Effect:
The thicker the wall thickness, the better the strength and the longer the
printing time.
3.
Allow reverse pumping:
Pull the filament back when printing.
Effect:
If not back pumping will produce filament drawing, affect the molding effect.
4.
Bottom/Top thickness:
The thickness of the bottom and top.
