12
3.2
Fine tuning
Select a model and wait for the printer to start printing, look at the print platform,
again to see the distance between the nozzle and the platform is probably a piece of
paper, and then start to print the debugging file, adjust.gcode, by looking at the the effect
of the first layer to fine-tune platform, print out the first layer can stop printing, fine-tune
and adjustment of the next print.
If the filament spilled out is serrated, the
distance between the platform and the
nozzle is too large, and the filament is
thrown down from the nozzle instead of
sticking tightly.
Turn the nut a little clockwise to make the
platform go up until the phenomenon disappears
and a tight line appears.
If the filament is found to be too thin or
incoherent, it means that the distance
between the nozzle and the platform is too
small, resulting in too small amount of the
nozzle.
Turn the nut slightly counterclockwise to
lower the platform until the wire output is full and
smooth.
Adjust well the effect of platform printing
should be full out of the filament and the line
pressure is flat on the platform.
