MyPower VG2000 V4 VoIP Gateway Installation Manual
Page
38 / 72
The device must be installed on the supporting board
or supporting bracket (using in pair) of the cabinet.
Therefore, install the supporting board or supporting
bracket in the cabinet in advance before insatlling the
device, as shown in the following figure. User a level to
check whether the supporting board or supporting
bracket is horizontal. If not, please adjust the fixed bolt
of the supporting board or supporting bracket to make
them horizontal and then tighten the bolt.
Figure 4-7 Cabinet diagram
Check whether the floating nut of the fixed device is
already installed in the square hole of the cabinet
upright post. If not, install the floating nut to the
corresponding square hole based on the supporting
board or supporting bracket location.
Generally, a device should be placed on a supporting
board or supporting bracket. It is not recommended to
