1.2 INSPECTION
Before and after disassembly,inspect each part for points mentioned below,and replace if necessary.
9.5 Kgf
(20.9lbs)
13.0-18.8 Kgf
(28.7-41.5lbs)
Synchro-hub thrust for shifting
-
51.17
㎜
(2.015 in)
Assembled width of
synchromesh assembly
0.3
㎜
(0.012 in)
0
㎜
(0 in)
Stepped wear of teeth
0.5
㎜
(0.020 in)
0.1 - 0.2
㎜
(0.004-0.008 in)
Backlash of each gear (measured
in meshed condition)
Usable limits
Standard values
Inspection items
-Inspect bearings such as ball bearings and needle bearings for abnormalities in rotation such as
irregularity,hitching,etc.by turning them with pressure applied by hand.Replace defective ones.
-Seriously worn or damaged parts should also be placed.
5-7
Summary of Contents for 2810
