Mahindra 2810, Service Manual

Page: 32 / 223

,Be sure to wind the wire paying
sufficient attention to its winding
direction and bend the lock washer for
secure looking.
4) When locking bolts and nuts with an
adhesive,apply the adhesive on the thread
and tighten securely.
5) Apply an adhesive(THREE BOND
TB1104) to parts through which there is
any possibility of oil leaks,such as stud
bolts and tapped-through parts.
6) Each lock nut must be tightened securely.
7) When tightening bolts and nuts, refer to
the tightening torque table.
(8) After installation, each grease
fitting should be filled with grease.
1) When installing grease fittings of
type B and C,be sure to turn the fitting
tips in a direction that will provide easy
access for a grease gun.
(9) Other precautions
1) Be sure not to damage any finished
surfaces or parts.
2) Always refrain from forcing installation.
3) Each lever knob should be installed
coated with an adhesive
(SUPER THREE CEMENT TB1702)
4) Each contact surface should be
coated with an adhesive(THREE BOND TB 1215)
and tightened evenly with bolts.
Adhesive coated surfaces should be installed within
30 minutes after application of the adhesive.
The contact surfaces should be flawless and free
from foreign matter,and especially from grease
before application of the adhesive.
5) Precautions for applying adhesives.
- The surface or the thread where and adhesive is to
applied should be completely free of chips.
- The surface or the thread where an adhesive is to
be applied should be completely free of oil-ness.
2-3