40
BA322301-en
6
Inspection
Depending on the conditions of use, the lift must be inspected at intervals of no
more than 12 months. In particular, safety devices, fastenings and load-bearing
components must be inspected. This inspection must be carried out by a
competent person to ensure safe operation also until the next inspection. The
inspection and its findings shall be documented.
6.1
Safety Information
WARNING
•
The relevant health and safety regulations must be observed.
•
Wear personal protective equipment.
•
Service work may only be carried out by authorised service technicians.
•
Repairs, maintenance and set-up work should only be carried out when the
machinery is stationary. The unit must be disconnected from the power
supply and secured against being switched on again.
•
Work on the electrical part of the lift may only be carried out by qualified
staff or specialist electricians.
ATTENTION: The 230V sockets on the control element(s) also carry current
after the system has been switched off!
•
Maintenance and repair work should only be carried out when the lift is
load-free.
•
Only use original replacement parts.
•
Substances that are hazardous to the environment must be disposed of
appropriately.
•
Do not use high or steam pressure equipment or harsh cleaning agents to
clean the lift.
•
The safety features of the lift must be set by authorised service technicians.
•
The safety features must not be replaced or overridden.
Summary of Contents for ZS SQUARE II 3.5
Page 16: ...16 BA322301 en 2 4 3 Set up Diagrams...
Page 32: ...32 BA322301 en B B 3 4 B C 5...
Page 52: ...20 PL670000_002 de...
