17
BA010101-en
6.3
Maintenance by the Operator
NOTICE
Relieve the pressure to remove the test plates; activate service mode for this pur-
pose (see section “Operation > Service Mode”).
•
Remove the test plates and lubricate the guides with a grease gun or grease
the plastic sliding strips every 200 operating hours, but at least every three
months. In the case of PMS plates installed in lift runways, lubrication can take
place directly from below.
•
Check that all the guide rods are secure and tighten them if necessary.
•
Check the oil level regularly and top it up if necessary. The oil level must be be-
tween the two marks.
•
Change the hydraulic oil every two years. Please see the section entitled “Spec-
ifications” for the filling quantity and specifications.
6.4
Greasing Points
Lubricating with
a grease gun
Greasing with a brush
PMS plates in lift runways (view: underside of the runways)
