7
BA010101-en
hand lamp matches the receiver’s channel. No equipment that might also re-
spond to this channel may be located anywhere on the premises. The unin-
tended operation of other equipment may put people at risk.
Furthermore, no transmission equipment that could respond to the axle play
detector may be located anywhere on the premises.
•
To prevent injuries caused by impact or being run over, a sufficient safe dis-
tance from the vehicle to be tested must be maintained when it is being driven
onto and off the test equipment.
•
Before testing, the vehicle to be tested must be secured against rolling away.
When used on sloped surfaces (e.g. access ramps in mobile test lanes), it is
advisable to have someone man the driver’s cab during testing so they can re-
spond to unintended movements.
•
Wear personal protective equipment.
•
A sufficient safety distance from the surface of the test plates’ movement area
must be maintained. Risk of crushing and shearing!
•
Test plates must not be walked on, even when not in use. There is a risk of fall-
ing due to unexpected test plate movements. There is a risk of slipping due to
water or ice on the test plates.
•
During operation avoid lateral shifting of the vehicle on the test plates and con-
tinually monitor the position of both wheels on the test plates. Should the
wheels move close to the edge of the test plates, stop the test immediately and
reposition the vehicle.
•
Periodically check the fastening screws of the test plates for tight fit.
1.7
Safety Instructions for Servicing
WARNING
•
Service work may be done by authorised service technicians only.
•
Turn off and padlock the main switch before doing any repair, maintenance or
setup work.
•
Work on the electrical equipment may be done by service technicians or certi-
fied electricians only.
•
Ensure that ecologically harmful substances are disposed of only in accordance
with the appropriate regulations.
