MAGUIRE Weigh Scale Blender 4088 TSC, Installation Operation & Maintenance

Page: 57 / 143

57
RAC 000000 Regrind Auto Control
This is a Six-digit parameter.
1st digit is the regrind component
2nd and 3rd digits are the cycle count
Last 3 digits are the % to increase current setting by.
Example: 110100 - Regrind #1, 10 cycles increase setting by 100%. Current
setting 25%, increases to 50%.
RLC 00000 Regrind Level Control – works with RHL
1st digit is the regrind component
Last digit the % to increase current setting when sensor covered and uncovered.
Example: 10005 - Regrind #1 increase 5% each cycle based on RHL setting.
RHL 00000 High Low Level Control - Requires level sensors
First 3 digits is the high percentage when upper sensor is covered
Last 2 digits are the low percentage when both sensors are uncovered.
Example 07020. Regrind setting at 50. If both sensors are covered increase
setting to 70%. If both sensors are uncovered decrease setting to 20%.
PTA – Additive as a Percent of Total
Enables up to 5 additives to run as percent of total.
Each digit represents a component.
Components are: 1-9, 10=A, 11=B, 12=C, 0=none
This parameter only works under Mode of Operation: % of Natural.
PAR 00000 Percent of Additive to Regrind
1st digit is the Regrind component.
2nd digit is the Additive component.
Last 3 digits are percent in tenths (##.#).
Example 15050: Regrind 1, Additive 5, 5%
KDF – Acceptable variation between readings for a valid weight (grams)
KDF is used only during load cell calibration.
See WDF for normal operation.
Variation in grams or 10ths of grams depending on blender model.
Micro Blender, 100, 200 Series = 10ths of grams
400, 900, 1800, 2400, 3000 Series = grams
Excessive vibration may require increase.
WDF – Acceptable variation between readings for a valid weight (grams)
WDF is used only during normal operation.
Variation in grams or 10ths of grams depending on blender model.
Micro Blender, 100, 200 Series = 10ths of grams
400, 900, 1800, 2400, 3000 Series = grams
Excessive vibration may require increase.
First digit = duration of reading in half second (1= 1/2 second … 5=2.5 seconds).