MAGUIRE Weigh Scale Blender 4088 TSC, Installation Operation & Maintenance

Page: 33 / 143

33
Material Flow Rate Calibration
If material is changed or hardware is changed (example: 1/2" auger changed to a 1" auger) and
material meters at a much lower or higher rate than expected, the software may take 10 to 20
cycles to fully adjust. During this time cycles will take longer. The software will SELF ADJUST the
flow rate or a Material Flow Rate Calibration can be done to set the flow rate immediately.
Material Flow Rate Calibration
Press
Display will prompt for a password. (default: 22222) Then press:
If you are calibrating an auger feeder, operate it briefly to ensure it is fully primed. To do so:
Press
Blender Configuration
Press Manual Operations Display will show Component 1, Component 2,…
Component 12 and Weigh Bin, Mixer, Alarm, and Hold.
Press Component 5 or Component 6
Run until Auger Feeder is dispensing.
Press again to stop the feeder.
Press Weigh Bin
This will empty the Weigh Bin
Now you can CALIBRATE the material. To do so:
Press to return to the previous screen
Press Calibration Routines
Press Flow Rate Calibration Display will show the currently select component and the
Current Flow Rate in grams per second.
Press To select the Component to calibration.
Press START Display will show: Calibrating…. Please Wait.
Component #5 will calibrate itself. When complete the
display will show the New Flow Rate.
Press
ACCEPT or REJECT
to accept and use the new flow rate or reject to keep the
current flow rate.
Repeat the calibration routine for EACH material that you wish to calibrate. Only components that have a
TYPE selected (not "OFF") will operate. Each time a dispense will occur, followed by weighing, followed by a
dump to empty the weigh bin.
Press
To return to the Main Screen.