MAGUIRE Gravimetric Gateway LineMaster, Installation Operation & Maintenance

Page: 25 / 93

Maguire Products, Inc.
25
LineMaster

XC-1 – Extrusion Control Installation
The XC-1 kit involves the installation of the following components:
 LineMaster Controller
 Extruder Drive Control
 Cabling
 Optional 24 volt power supply
Install the XCD-X Extruder Drive Control in your desired location.
Remove the front cover from the Extruder Drive Control box (see General Installations
Notes).
Run the Controller Cable from the LineMaster Controller’s 7-pin receptacle to the
Extruder Drive Control. The un-terminated side of the cable will be on the Extruder
Drive Control side and should be cut to length leaving enough cable to run into the
Extruder Drive Control box.
Strip back approximately 2 ½ inches of the outer shielding from the un-terminated
side of the cable to expose the 5 wires. Run the Controller Cable into the Extruder
Drive Control box, through one of the two hole locations on the Control box. Use a
stain relief if necessary. Strip back approximately ¼ inch (6mm) per wire and install
into the terminal strip (see wiring diagram on the following page for exact wire
locations).
Run the Extruder Drive wire into the Extruder Drive Control box and install into the specified terminal
strip as indicated in the wiring diagram.
If you are using the optional 24 volt power supply to power the
Extruder Drive Control, install the power supply in a desired location.
Run a length of shielded, 2-conductor 18 gauge wire from the power
supply to the Extruder Drive Control and wire according to the XC-1
Extrusion Control Wiring Diagram.
If the Extruder Drive Control will be powered by your 0-10 volt Extruder Drive Cable, REMOVE the
jumper between J14 and J15 located on the On the Extruder Speed Control Interface circuit board.
If the Extruder Drive Control will be powered by the optional 24 volt power supply (to provide an isolated
power source), DO NOT remove the jumper between J14 and J15 located on the On the Extruder
Speed Control Interface circuit board.