4 - Command Set
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer’s Manual (COMMANDS)
Page 42 of 247 (
D998200136-31
)
4.3.3
Command 0x03 - Request Swipe Card
This command directs the device to prompt the cardholder to swipe a card by displaying one of four
predetermined messages (see Card Message ID in
). Example request screens look like this:
Figure 4-2 - DynaPro Go Swipe Prompts
If an error occurs, the device terminates the command and reports the error in ACKSTS of
. For a full list of error codes, see
When this command completes (card swiped OK, cardholder or operator cancelled, or timeout), the
device sends
Report 0x22 - Card Status Report
to the host. If the Card and Operation Status are both
Command 0x0A - Request MSR Data
to get the card data.
For an example of using this command, see
Appendix A.1 How to Get MSR/PIN Data from the Device
Table 4-4 - Usage Table for Command 0x03
Bit
7
6
5
4
3
2
1
0
Byte 0
0x03
Byte 1
Wait time in seconds, (0x01..0xFF; 0x00 = Infinite wait time)
