4 - Command Set
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Programmer’s Manual (COMMANDS)
Page 143 of 247 (
D998200136-31
)
4.6.2
Command 0xE2 - Set / Get Wireless Timeouts (802.11 Wireless Only | PCI
Bluetooth LE Only)
The host uses this command to set or get the timeout values for the device’s wireless connection.
If an error occurs, the device terminates the command and reports the error in ACKSTS of
. For a full list of error codes, see
Table 4-91
- Usage Table for Command 0xE2 (Set Limit Time Values in minutes)
Bit
7
6
5
4
3
2
1
0
Byte 0
0xE2
Byte 1
Timeout Selection
(802.11 Wireless Only)
0x00 =
Inactive Connection Timeout.
Period of time the device will maintain an 802.11
wireless TCP session connection with the host when there is no host activity. If no host
activity occurs during the timeout period, the device closes the session connection. The
timeout must be between 1 and 15 minutes, or the device rejects the command. Default is
2 minutes.
0x01 =
Sleep Timeout
. Set how long the device will stay powered on in the absence of
operator activity or host activity on the wireless connection, before it automatically enters
sleep mode. The timeout must be between 1 and 255 minutes. Default is 2 minutes.
Byte 2
Timeout Value in minutes
Table 4-92
- Usage Table for Command 0xE2 (Get Limit Time Values in minutes)
Bit
7
6
5
4
3
2
1
0
Byte 0
0xE2
Byte 1
Inactive Connection Timeout (802.11 Wireless Only, otherwise Reserved)
Byte 2
Sleep Timeout
