MC-35A
Auto creaser
23
positioning on the template.
2.
When creasing in the middle of register mark, accuracy is
±
0.3mm.
3.
Distance from the leading edge(D1) is over 10mm. Distance to the tail(D2) is
over 50mm.
4.
⑴
When the distance between two mark(D) is over 5mm, the function
6.3.2.2
is available.
⑵
When D is over 25mm, the function
6.3.2.1
is available.
5.
All area above or the Grey Area (Area A) should be blank, because other
colo
u
r may affect the mark reader.
6.4 Hardware Settings
6.2.1 Crease Depth
Crease depth is important to crease quality. It just depends on the gap
between male die and female die. Depth should be adjusted according to the
paper thickness. Low Depth will perform a not clear crease. But a high Depth
may cause cracking or system take it as a double feed.
The adjustment is also needed if the crease depth are not balance on both
sides.
Normal
Too light
Crack edge
Not balanced
Too heavy
To adjust the Depth:
Open the safety cover and you will see following picture
Find 4 screws on both side, turn the Allen screw according to the label
