Auto creaser
10
MC-35A
5 QUICK START
Paper must be flat and not curled ,not hooked, cut straight and square
1.
Turn on machine,
2.
To lower tray
feed
, press
STOP
3.
Put paper in the tray
，
against the fixed guide, front and side.
4.
Fit tray and outfeed tray extensions as required if over A3 , Pile must be
even
and square.
5.
Position side guides close to the side and the end with enough gap to let
the
paper move freely.(Ca. 0.5 mm gap)
Never put the guides under the
feed
head or they may get trapped when the tray lifts and destroy the
feed
head, and invalidate the warranty
6.
Set the guides on the output tray to catch the paper
7.
Adjust front air blast by left knob according to paper weight.
Heavy=>more
=anti clockwise ,light=>less=clockwise
8.
Adjust pile height limiter as needed, clockwise = higher, anti-
clockwise
=lower
9.
Adjust front separator by right knob according to paper caliper, thick=
down=
clockwise, thin=up=anti-clockwise.
10.
As necessary, adjust crease steps, using the 4 screws on crease
bar,
clockwise=down, anti-clockwise= up, adjust max 1/4 turn evenly on all 4
at a
time.
11.
Adjust skew as needed to correct front cut errors, knob down =paper to
the
right, knob up =paper to the left
12.
For thin paper you may need to use 1 or 2 magnetic deflectors to stop
the
paper lifting.
13.
Input line position from front edge from 0-32 lines, min 1mm max 650,
min
spacing 0.5mm.Press M enter 1st line value, press enter 2
nd
line value……
press enter twice to quit.
14.
Input quantity max value 999, counter will count do
wn
and stop at 0,
15.
For test press gray button once,=1 cycle, tray will lift and fans will run up.
16.
Check the result, and compensate as needed.
17.
Press green button to run, tray will lift and fan will run.
18.
Press red to stop, or the machine will stop when preset is reached, tray will
drop.
