Auto creaser
23
MC-35A
6.3.2
H
ow to Use Sniper?
6.3.2.1
Read Mark and Crease Finished In One Cycle.
Use this function
，
all sheets have to be printed with register mark.
1. Put a pile sheets on loading table. The side with register mark must in
non-operation side.
2. Activate Sniper as per
6.3.1
.
3. Press Start Key to run machine. It will crease as per register mark.
Note:
1. In this condition, press Test Key machine will only pass one sheet
without crease.
2. In this condition, Use
Read CR Data
to read the mark position data.
3. In this condition, Use
Read and Test
to check if the crease line
is matched with the mark well.
6.3.2.2
Read Mark First and then Crease .
This function is aim
ed
to create a job quickly and crease on the sheet
without register mark. You only need one sheet with register mark on it to get
the data. 1.
Turn off Sniper as per
6.3.1
.
2. Press Mode Key
twice entering
Read CR Data
or three times entering
Read and Test
.
3. Pass through one sheet with register mark. And machine will read all data.
4. Feed sheet without register mark and machine will crease as per the data.
6.3.3 How to Create a Register Mark ?
The register mark (black area) is always at right edge. The Mark only works if it
is in right size and right place.
L
A
D1
W
D
D2
Feeding Direction
1. Mark size (L*W) should be more than 5*2,(L
≥
5, W=2.0
±
0.5mm). Optimum
length (L) is 7~10mm. Mark right edge keep abreast with the right edge while