Auto creaser
14
MC-35A
6.2.3
i
nput Crease Data Screen
Initially in this Mode, cursor flashes in Line 1), (which means data can be
input), input the data , from 0-650.0,accurate to one decimal place.
Press ENTER, cursor turns from 1) to the next line, namely line 2) and flashes
in line 2).Input a data, press ENTER. cursor turns from 2) to the next page,
namely line 3) and flashes in line 3). The rest can be done in the same manner.
Note:
1. Each value has to be greater than last value.
2. If all 6 lines are needed, after we Enter the 6th data, screen will
automatically jump to MODE 1, page 1. Input finished.
If less than 6 line is needed, after we finish the last data (say, the 3rdline ),
Enter, Line[4] flash, press ENTER again when line[4] is 0, screen will
jump to main operation mode, input finished.
6.2.4
r
ead Crease Data Screen
Press TEST Key
and feed one sheet. Machine will read the data by
scanning the mark. Then go back to Ready Screen.
Note:
In this mode, machine only read data as per register mark not creasing.
6.2.5 Read and Test Screen
Press TEST Key
and feed one sheet. Machine will read the data by
scanning the mark and Crease at the same time. Then go back to Ready
Screen.
Note:
In this mode, you can check the crease position is
correct
.
