Magnum Industrial MI-91500, Operating Manual

Page: 4 / 24

3
LIST OF CONTENTS
For your convenience this band saw is shipped from the
factory partially assembled and requires only minimal
assembly and set up. In addition to your new band saw
(not shown), the carton should contain the following:
• (A) BAND SAW (not shown)
• (B) TABLE
• (C) TABLE LOCK KNOB (x2)
• (D) MITER GAUGE
• (E) MITER GAUGE STORAGE BRACKET
• (F) RIP FENCE STORAGE BRACKET
• (G) 8 MM ALLEN KEY
• (H) 3 MM ALLEN KEY
• (I) 10-12 MM OPEN END WRENCH
• (J) FOOT BRAKE
• (K) CAP SCREW (x2)
• (L) LOCK WASHER (x2)
ADDITIONAL REQUIREMENTS FOR SET UP
• Extra person to help lift
• Phillips screwdriver
• Flat head screwdriver
• 10 mm wrench
• 15 mm wrench
• Feeler gauge set
• Combination square
ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-91500 DELUXE 14” BAND SAW
• Before you assemble your band saw, review the parts breakdown and keep it ready for reference.
• Start by removing the parts from the packaging.
• Carefully check the packaging for small pieces before you continue.
• Lay out the parts on a large, clear and unobstructed area and ensure that all parts are accounted for.
• If you have any questions or require further information, please contact the KMS Tools Service Department at 604.395.4134
or email repairs@kmstools.com
FIGURE 3: CONTENTS
WARNING!
Serious personal injury could occur if you
connect the saw to the power source before
you have completed the installation and
assembly steps!
3