5
ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-91500 DELUXE 14” BAND SAW
ATTACHING THE STORAGE BRACKETS
The MI-91500 is equipped with onboard storage brackets
to store the rip fence and miter gauge when not in use.
Attach the rip fence storage bracket and miter gauge
storage brackets to the back of the saw as shown in
Figures 5 and 6, using the bolts and washers already
mounted to the saw.
ATTACHING THE TABLE
The worktable mounts on a bracket.
This bracket can adjust from 0° to 45°
to the right. These adjustments are easy
to make with the angle scale and lock
knobs.
1. Remove the
RED INSERT (A)
from
the centre of the table and the
TABLE ALIGNMENT PIN (B)
from
the table slot. See Figure 7.
2. Turn the table right side up.Verify
that the
LONG BOLTS (C)
in the
centre of each trunnion are pointing down. See Figure 8.
3. Carefully position the table over the
TABLE-TILT BRACKET (D)
, guiding the saw
blade through the
TABLE SLOT (E).
See Figures 9 and 10.
Note: If the long bolts have moved out of position, have an assistant tap them into
place with a screwdriver.
FIGURES 5 and 6: STORAGE
FIGURE 7: TABLE INSTALLATION
FIGURES 8, 9 and 10: TABLE INSTALLATION
8
5
7
6
10
9
Summary of Contents for MI-91500
Page 1: ...MODEL NO MI 91500 OPERATING MANUAL...
Page 20: ......
