4
ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-91500 DELUXE 14” BAND SAW
LIFTING AND HANDLING THE MACHINE
To limit the potential for damage in transport, this band saw is shipped from the factory bolted to its crate in a vertical position.
With a forklift or hydraulic pallet jack, move the entire crate as close to the final installation location as possible, and then
uncrate the saw and remove the four bolts that secure it to the crate using a 15 mm wrench.
PLACING THE BAND SAW IN YOUR SHOP
This machine should be installed and operated on a solid, flat and stable floor that can support the weight of the band saw
and the operator. Using the dimensions shown as a guideline, plan for placement within your shop that will allow the operator
to work unencumbered and unobstructed by foot traffic (either passing shop visitors or other shop workers) or other tools or
machinery.
ESTABLISHING A SAFETY ZONE
Shops with frequent visitors or multiple operators should
establish a safety zone around machinery. A clearly defined
safety zone on the floor around each machine can help avoid
accidents that could cause injury to either the operator
or the shop visitor. Mark out the safety zone with non-
slip paint or tape. Take steps to ensure that all operators
and shop visitors are aware that these areas are off limits
whenever a machine is running.
CLEANING THE SAW
The protective coating on the saw table prevents rust from forming during shipping and storage. Remove it with a rag dipped in
environmentally friendly degreaser and dispose of the rag according to the degreaser manufacturer’s safety recommendations. To
clean the T-slots, push the rag through the slots with a screwdriver. If necessary, scrape the coating with a putty knife held flat
to avoid scratching the surface and then clean with degreaser. Avoid rubbing the saw’s painted surfaces. To prevent rust, apply a
light coating of paste wax or use regular applications of any aftermarket surface protectant or rust inhibitor.
WARNING!
This saw is heavy. You will need the help of at least one other person or a hoist for the following
steps! To limit the risk of serious injury or damage to the machine, any equipment used to lift this
machine must have a rated capacity in excess of 297 lbs (133 kg)!
WARNING!
Do not connect the saw to the power source until instructed to do so!
FIGURE 4: SAFETY ZONE
4
Summary of Contents for MI-91500
Page 1: ...MODEL NO MI 91500 OPERATING MANUAL...
Page 20: ......