11
57-642 ECLIPSE Model 705 Guided Wave Radar Transmitter for Hygienic Industries
2.4.2 Installing the Transmitter
The transmitter can be ordered for installation as an
Integral or Remote configuration.
2.4.2.1 Integral Mount
➀
Remove the protective plastic cap from the top of the
probe. Store the cap in a safe place in case the transmitter
has to be removed later.
➁
Place the transmitter on the probe. Be careful not to bend
probe. Do not allow the gold, high frequency (male) con-
nector to become dirty.
➂
Align the universal connection at the base of the transmitter
housing with the top of the probe. Hand-tighten the
connection.
➃
Rotate the transmitter to face the most convenient direction
for wiring, configuration, and viewing.
➄
When the transmitter is facing the desired direction, use a
1
1
⁄
2
" (38 mm) wrench to tighten the universal connection on
the transmitter to 45 ft-lbs (60 Nm). A torque wrench is
highly recommended. This is a critical connection. DO
NOT LEAVE HAND-TIGHT.
2.4.2.2 Remote Mount
➀
Mount the transmitter/remote bracket as an assembly within
33" or 144" (84 or 366 cm) of the probe. DO NOT
REMOVE TRANSMITTER OR REMOTE CABLE
FROM BRACKET.
➁
Remove the protective plastic cap from the top of the
probe. Store the cap in a safe place in case the transmitter
has to be removed later.
➂
Align the universal connection at the end of the remote
assembly with the top of the probe. Using a 1
1
⁄
2
" (38 mm)
wrench, tighten the universal connection on the transmitter
to 45 ft-lbs (60 Nm). A torque wrench is highly recommend-
ed. This is a critical connection. DO NOT LEAVE HAND-
TIGHT.
➀
➁
➂
➃
➄
➀
➁
➂
