MAGNAWELD RS 350 M PRO, User Manual

Page: 20 / 200

20 RS 350 - 450 - 550 M / MW PRO
EN
www.magmaweld.com USER MANUAL
Installation
• If you will use the gas cylinder on the gas cylinder transport platform on the machine, place the gas cylinder
here and secure it with a chain.
• If you will not place the gas cylinder on the machine, secure the gas cylinder to the wall with a chain.
• Use safety regulators and heaters according to the standards for work safely to achieve the best results.
• Make sure the size of the hose connection of the gas regulator you are using is 3/8 .
• Open the gas cylinder valve keeping your head and face away from the outlet of the valve and keep it open for
5 seconds. By this means, possible sediment and impurities will be discharged.
• If the CO 2 heater is to be used, first connect the CO2 heater to the gas cylinder. After connecting the gas
regulator to the CO 2 heater, insert the plug of the CO 2 heater into the CO 2 heater outlet on the back of the
machine.
• If the CO 2 heater will not be used, connect the gas regulator directly to the gas cylinder.
• Connect one end of the tube hose to the gas regulator and tighten the clamp. Connect the other end to the gas
inlet at the back of the machine and tighten the nut.
• Open the gas cylinder valve to check that the tube is full and that there are no leaks in the gas flow path. If you
hear a noise and/or detect a smell of gas as a leak indicator, examine your connections and eliminate leakage.
2.4.5 Gas Connections
1-
Gas Cylinder Valve
6-
Gas Regulator
2-
Gas Cylinder
7-
Manometer
3-
CO 2 Heater
8-
Flowmeter
4-
Chain
9-
Flow Adjustment Valve
5-
CO 2 Heater Energy Cable
10-
Gas Hose
Figure 5 : Gas Cylinder - Heater - Regulator Connections
1
2
5
4
3
6
7 8
9
10