MAGNAWELD RS 350 M PRO, User Manual

Page: 23 / 200

23 RS 350 - 450 - 550 M / MW PRO
EN
www.magmaweld.com USER MANUAL
Pnt Mode
Welding starts as soon as the trigger is pressed and welding continues for the specified
on-time period and stands by during the length of off-time; the process continues as
long as the button is pressed. Welding will also be terminated when the trigger is
released.
If pnt is selected in the Trigger mode, the On and Off times as well as the welding and
standby times are determined.
On time (Ont)
In pnt mode, the time the welding is active will be set. During this time, the welding will
continue and the welding will stop at the end of the period.
Setting range:
0 - 10 sec.
Off Time (OFt)
Stand-by time during welding is adjusted in pnt mode. During the set time, the welding
will stop and restart at the end of the period.
Setting range:
0 - 10 sec.
Standby Mode (SLC)
When the machine is not used after the time set for sleep mode, it goes into standby
mode. This prevents unnecessary energy consumption.
Setting range:
On - Off
Soft Start (SoS)
When the source is first started, the wire speed rises slowly from the lowest speed until
reaching the set speed. By this means, backlash and spatters are prevented at the
beginning of the welding process.
Setting range:
On - Off
Cooling Time (Cot)
After the use of machine has been completed, the water-cooling unit continues to
operate for the set period of time. This prevents hot water from damaging the torch.
Setting range:
4 - 10 min.
Operation