DASHBOARD CONTROLS
C - THROTTLE/CHOKE CONTROL (ITC)
The throttle and choke are combined into one
sturdy handle.
For
COLD ENGINE STARTS
, pull handle upward
to the
“Choke” position, as far upward as pos-
sible.
As soon as the engine starts, move handle
into the “Throttle” range.
For
WARM ENGINE STARTS
, (when you have
been using the unit and the engine is warm), move
the handle
to the “High Throttle” position.
As
soon as the engine starts, move handle into the
“Throttle” range.
Adjust handle as needed in the Throttle position
of choice. Fuel comsumption is better at lower
ranges.
Adjusting your Power vs. Speed is
done mostly in the Left & Right Track Drive
Controls.
Push the track drive controls
“slightly”
forward or rearward to achieve
“maximum
power”.
Push the track drive controls
“fully”
for-
ward or rearward to achieve
“maximum speed”.
Though all crawlers by their design are somewhat
“rough riding”, you can minimize the “roughness”
by traveling at the lowest speeds when going over
hard surfaces.
Before turning off tractor, move Throttle/Choke
Control handle to the
ON SHUT- OFF
position.
D - HEADLIGHT SWITCH (If equipped)
The Headlight Switch is a basic “Pull ON”, “Push
OFF” switch. Behind the dash, in the wiring har-
ness, is a replaceable Safety Fuse. When replac
ing, use a new fuse of the same amps as the one
being replaced.
E - KEY IGNITION SWITCH
Switch is activated by rotating key clockwise.
Turning it fully clockwise will engage engine starter
...release key and it will return automatically to the
RUN “ON” position. Turn fully counter-clockwise
to OFF position to stop engine. Remove key.
F - HOUR METER /TACH (If equipped)
The Hour Meter/Tach dis-
plays the hours run and the
RPM of the engine. Keeping
up with your maintenance of
your MAGNATRAC keeps it
running in top condition!
Flashes
“CHG OIL”
at
100 hour
service intervals
and
“LUBE”
at
25 hour
service intervals, the
service interval is based on actual run hours.
OPERATION & SERVICE RESET:
Alerts begin flashing a warning 4 hours before
service is due, and clear automatically 1 hour af-
terward. Meter displays RPM while engine is run-
ning, hours while engine is off. Service alarms will
automatically reset 1 hour after service interval.
13
A
A
D
F
C
E