EN
www.magmaweld.com
25
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
RS 350 M / MW PRO - RS 450 M / MW PRO - RS 550 M / MW PRO
3.4 Selection and Replacement of Wire Feed Rollers
• Open the cover of the wire feed part. You will see the four-roller wire feed system.
• Use wire feed rollers suitable for the material and diameter of the welding wire you will use. Use
V-grooved wire feed rollers for steel and stainless steel, corrugated V-grooves for cored wires
and U corrugated ones for aluminum.
• If you need to replace the wire feed rollers, pull the pressure roller lever toward your side and
after lifting the pressure rollers, remove the wire feed roller screws and remove the existing
rollers (Figure 18).
• After inserting the rollers, you will use, re-insert the screws and lower the pressure rollers and
lock the pressure roller lever onto the rollers (Figure 19).
Both sides of the rollers are marked according to the wire diameter used. Place the rollers on the flange so that the
wire diameter value you will use will be on the side facing your side.
1-
Engine
2-
Euro Connector
3-
Pressure Roller Handle
4-
Pressure Rollers
5-
Wire Feed Rollers
6-
WF Roller Screws
Figure 17: Wire Feed System
Figure 18 : Wire Feed Roller Removal
Figure 19 : Wire Feed Roller Placement
1
2
3
4
4
5
5
6
6
Operation
