Magmaweld D 500 TW DC PULSE, User Manual

Page: 5 / 132

EN
5
www.magmaweld.com USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
ID 500 TW DC PULSE
Be Sure To Follow All Safety Rules In This Manual!
Make certain that the installation procedures comply with national electrical
standards and other relevant regulations, and ensure that the machine is
installed by authorized persons.
• Safety symbols found in the manual are used to identify potential hazards.
• When any one of the safety symbols are seen in this manual, it must be understood
that there is a risk of injury and the following instructions should be read carefully
to avoid potential hazards.
• The possessor of the machine is responsible for preventing unauthorized persons
from accessing the equipment.
• Persons using the machine must be experienced or fully trained in welding; they
have to read the user manual before operation and follow the safety instructions.
• Read the user manual, the label on the machine and the safety instructions carefully.
• Make sure that the warning labels on the machine are in good condition. Replace
missing and damaged labels.
• Learn how to operate the machine, how to make the checks in a correct manner.
• Use your machine in suitable working environments.
• Improper changes made in your machine will negatively affect the safe operation
and its longevity.
• The manufacturer is not responsible for the consequences resulting from the
operation of the device beyond the specified conditions.
• Wear dry and sturdy insulated gloves and working apron. Never use wet or damaged
gloves and working aprons.
• Do not work alone. In case of a danger make sure you have someone for help in your
working environment.
• Do not touch the electrode with the bare hand. Do not allow the electrode holder or
electrode to come in contact with any other person or any grounded object.
• Never touch parts that carry electricity.
• Never touch the electrode if you are in contact with the electrode attached to the
work surface, floor or another machine.
• By isolating yourself from the work surface and the floor, you can protect yourself
from possible electric shocks. Use a non-flammable, electrically insulating, dry and
undamaged insulation material that is large enough to cut off the operator’s contact
with the work surface.
• Do not connect more than one electrode to the electrode holder.
• Clamp work cable with good metal-to-metal contact to workpiece or worktable as
near the weld as practical.
• Do not touch electrode holders connected to two welding machines at the same time
since double open-circuit voltage will be present.
• Keep the machine turned off and disconnect cables when not in use.
Explanation Of Safety
Information
Comprehending Safety
Precautions
Electric Shocks
May Kill
Explanation Of Safety
Symbols
ATTENTION
Indicates a potentially hazardous situation that could cause injury or damage. In case
if no precaution is taken, it may cause injuries or material losses / damages.
IMPORTANT
Specifies notifications and alerts on how to operate the machine.
DANGER
Indicates a serious danger. In case if not avoided, severe or fatal injuries may occur.
SAFETY PRECAUTIONS
Safety Precautions