Magmaweld D 500 TW DC PULSE, User Manual

Page: 19 / 132

EN
19
www.magmaweld.com USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
ID 500 TW DC PULSE
1- TIG Curve
Use the buttons to scroll through the parameters in the TIG curve. The led of the relevant parameter
will light up depending on which parameter is selected.
8 7 1
3 2 4 5 6
3.1 User Interface
OPERATION
Start Current
The welding arc will occur at the specified current value. The value is set in terms of %. Start
current occurs below the specified% value of the main current and allows adjustment from
5A - %100.
Pre Gas
Darkening - deformation may occur in the welding area, if the shielding gas comes later
than the arc start. In order to prevent this deformation, you can adjust pre gas timing before
arc. Furthermore, the life of the tungsten tip will be shortened. Initial gas function allows
adjustment between 0 -20 sec. By this setting, it is ensured that the gas reaches the welding
area before starting welding.
Operation