Page 34
3.9. Installation Procedure
Before commencing installation, ensure that the intended installation will comply
with details in
General Information
on Pages
1
and
22
.
Carefully unpack the contents of the carton and check them against the checklist given on the
previous page.
Make sure that the fireplace opening is suitable for the installation of the fire and prepare the
fireplace to suit the dimensional requirements given in section
3.6
(i.e. fitting the fire surround,
the hearth (if required) etc.).
3.9.1. Preparing the Firebox
1. Remove the two burner fixing screws
located under the front corners of the
tray (see
Figure 48
to
Figure 50
on
Page
28
).
2. Withdraw the burner from the firebox,
taking care not to damage the ceramic
back and side panels. Place the burner
away for later use.
3. Apply the foam sealing strip all round the
rear edge of the firebox flange by
removing the protective backing paper
(see
Figure 63
).
Do not
fit this seal if
fitting into a Freedom Surround.
4. Unpack the cable fixing kit and feed the
cable ends through the top holes on the
sides of the flue outlet (see
Figure 64
).
5. If fitting the fire into a 125mm flue
system, remove the
flue restrictor
(see
Figure 64
).
Seal
Figure 63
Cables
Flue
Restrictor
Figure 64
Summary of Contents for Ekos 16"
