Page 36
3.9.3. Freedom Surround Installation (if applicable)
1. Using
Figure 68
, mark out and create
the appropriate opening to
accommodate the Freedom Surround.
2. With reference to
Figure 68
, mark out,
drill, plug and fit the eight eye screws
(outer four for fitting the Freedom
surround and inner four for fitting the
fire-box).
3. Install the gas supply within the opening
using rigid or semi-rigid tubing allowing
for rear entry into the fire box. (See
Figure 68
).
4. Remove the base plate (see
Figure 71
),
then fit the sealing strip to the rear of the
flange, as shown in
Figure 69
.
5. Place the Freedom Surround into the
prepared opening, threading the cables
through the outer eye screws, and
through the holes in the base of the
surround, as shown in
Figure 70
.
6. Tighten the cables using the cable
tensioning screws, ensuring that the
surround remains square and true, and
an effective seal is obtained between the
flange and the finished wall.
7. Refit the appropriate base plate, using
screws provided.
8. The inner four eye screws will be used to
secure the fire.
9. If installing Optimum Control Model
prepare a suitable route for the cable to
the wall switch.
10. Continue installation of the firebox as
detailed in
Section 3.9.6
FLANGE 25mm ALL ROUND
125mm
67
5m
m
545mm
Figure 67 - General Dimensions
LINTEL
150mm
150mm
30mm
68
5m
m
50
0m
m
635m
m
150mm
150mm
90mm 90mm
100
m
m
140mm
140mm
C
L
585mm
gas
inlet
12
2
50-120
Figure 68
SEALING
STRIP
Figure 69
Summary of Contents for Ekos 16"
