Magiglo Ekos 16", User, Installation & Servicing Instructions

Page: 44 / 60

Page 40
3.9.7. Connecting the Gas Supply
The gas supply to the fire must be carried out using rigid or semi-rigid metal tubing. A service
cock must be incorporated near the appliance to facilitate isolation of the fire during servicing.
An isolating valve (with a pressure test point) has been supplied with this fire.
Carry out the procedure below to prepare the
gas supply to the isolating valve supplied:
1. Cut a cross-slot in the rubber grommet
and push it onto the gas line to seal the
gas inlet slot on the firebox.
2. Fit the easy-fit pipe to the inlet of the gas
valve and fit the isolating valve loosely to
it. This is used for marking purposes.
3. Re-place the burner into the firebox and
mark the desired position of the gas inlet
pipe.
4. Remove the burner, cut the gas inlet
pipe as required and fit the isolation
valve (ensure this is in the correct
position, with the pressure test point
facing forward).
5. Replace the burner tray ensuring that the
rear of the burner tray assembly slots
into the rear support (see
Figure 76 ).
6. Connect the isolation valve on the gas
inlet pipe to the easi-fit pipe on the valve.
7. Fix the tray in position using the
previously removed screws.
8. If installing Manual BM Control option
proceed directly to Section 3.9.12 to
commission the fire.
9. For other control options proceed to the
appropriate section.
Rear
tray support
bracket
Tray
Fire back
Front
tray support
bracket
Side view of tray
Figure 76