Page 39
4. S
ERVICING
I
NSTRUCTIONS
NOTE:
For any spare parts that are required, please contact either your supplier
or the manufacturer directly. You will need the model name i.e. Model Number,
the gas type, the type of control and serial number.
Only approved parts should be used.
4.1. General Requirements
All repairs and servicing must be carried out by a qualified registered gas installer (e.g.
member of Gas Safe in GB) in accordance with the current Gas Safety (Installation and Use)
Regulations and these instructions.
WARNING: Before any servicing is carried out ensure that the gas and electric supply
to the appliance are turned off.
Always check for gas soundness after dismantling or exchange procedures.
4.2. Servicing Instructions
4.2.1. Fan and Flue Servicing
1. From the outside (at the fan box) remove
the fan box cover and dismantle the fan
from the fan box and clean the impeller
blades of any soot or debris.
2. Ensure flue outlet terminal is not
damaged and is free of obstructions.
3. With the gas and electricity supply on,
and the fan on, check the ignition of the
pilot. Check that the main burner cross
lights satisfactorily from the pilot.
4.2.2. Cleaning the Fan Impeller
1. From the outside (at the fan box),
remove the fan box cover and remove
the fan from the fan box.
2. Clean the impeller blades of any soot or
debris using a brush.
4.2.3. Servicing the Fire
1. Ensure that the fire is completely cold
before progressing.
2. Lay a suitable protective cloth over the
hearth and directly in front of the fire to
collect any dust or debris that may result
during servicing procedure.
3. Carefully remove all the coals and place
them to one side. Any coals that may
contain any soot or debris may be
carefully cleaned by brushing very lightly
with a soft brush.
4. Remove the gas connection to the fire.
5. Remove the two screws securing the
burner tray to the fire box and disconnect
the solenoid cable, then carefully
withdraw the burner tray forward.
6. Turn the burner tray upside down to
remove the ceramic burner board.
Handle the board very carefully.
7. The board can be cleaned by lightly
brushing the top surface with a soft
brush.
