Page 35
3.9. Completing the Installation
3.9.1. Electrical Wiring
Connection can be made using one of the
following methods:
a) A fused spur providing 230v 50Hz AC,
protected with 3A fuse, located adjacent
to the appliance.
b) A BS1363/A approved (three pin) plug
with a
3 Amp
rated fuse, can be fitted
to the power supply cable on the
appliance and plugging into a suitable
wall socket nearby.
The wires in the mains power supply lead on
the appliance must be connected to the plug
in accordance with
Figure 50
.
In case the appliance needs to be isolated
from the power supply (e.g. during servicing)
switch off at the wall socket and
REMOVE
THE PLUG
from the socket.
The electrical Installation must be carried out
in accordance with The Current I.E.E. Wiring
Regulations.
Connect BLUE
to N(neutral)
Outer Sleeve
firmly clamped
Cable grip
Connect BROWN
to L (live)
3Amp
fuse approved
to BS1362
Connect GREEN/YELLOW
to E or (earth)
Figure 50
3.9.2. Fitting the Fire Tray
1. Remake the connection between the
plug and the socket for the solenoid
valve. Because the plug and socket are
keyed, they will mate in one position
only. Do not attempt to force them
together.
2. Reposition the tray into the firebox and
secure it with the previously removed M5
screws ensuring that the tray rests on
the rear support.
3. Connect the gas supply to the inlet to the
isolating valve.
4. Complete fitting the fire surround / false
chimney breast ensuring that no
combustible constructional material is
less than 150mm from any ductwork or
the rear surfaces of the firebox. Insulate
the firebox with suitable insulation (e.g.
Rock wool) if necessary.
5. Fit suitable covers to all the exposed
insulated ductwork.
6. Make good with suitable material any
gaps in any internal and/or external
brickwork.
