Page 10
2.5. Fitting Standard Trim (if supplied)
1. Most trims are coated with a protective
film. This must be removed by peeling
off before fitting the trim.
2. The trim is held on by four magnets.
These will either be attached to the trim
or supplied loose in a separate envelope.
Space them as shown in
Figure 16
.
3. Offer the trim onto the flange of the
firebox. The magnets will hold the trim in
position.
4. Centralise the trim as necessary.
Magnets
Figure 16
2.6. Fitting ioss Fascia (if supplied)
1. The Fascia is coated with a protective
film. This must be removed by peeling
off before fitting the fascia.
2. The fascia is held on by four magnets.
These will either be attached to the trim
or supplied loose in a separate envelope.
Position them as shown in
Figure 17
.
3. Offer the fascia onto the flange of the
firebox. The magnets will hold the fascia
in position.
4. Centralise the trim as necessary.
5. The removable cover can be lifted off to
access the controls.
MAGNETS
Removable
cover to access
controls
MAGNETS
Figure 17
