Page 35
3.7. Installation Procedure
If applicable, carefully unpack the contents of the carton and check them against the checklist
given in
Section 3.6
.
Make sure that the fireplace opening is suitable for the installation of the fire and prepare the
fireplace to suit the dimensional requirements given in sections
3.2
and
3.4
(i.e. fitting the fire
surround, the hearth, etc.).
2.1.1. Installing the Fire
1. Place the fireplace furniture (fire basket,
swans nest, etc.) centrally within the
fireplace opening or under the canopy
making
sure
that
the
minimum
dimensions shown in
3.4 - Appliance
Location
are adhered to.
2. If the fire is fitted with legs, place the fire
tray inside the fireplace furniture, then
mark and drill the appropriate fixing
holes.
3. Fit the heat shield if applicable.
4. For all models, place the burner centrally
within the fireplace opening and position
it as far back as possible.
5. No part of the burner tray should be
allowed to project beyond the vertical
plane of the fireplace opening.
6. Connect the gas supply to the inlet of the
gas valve via the isolating valve where
supplied. Route the cable for the
Optimum Control if applicable
7. Remove the transit tape.
8. For Manual Control models, proceed to
Section 3.7.5
. For other control options,
proceed to instructions from those in
Sections 3.7.1
to
3.7.4
as applicable.
3.7.1. Continuation of Installation - Remote Control Model
1. Unpack the box containing the Receiver
and the Hand Set.
2. Fit four AA (1.5V) batteries into the
receiver unit and the PP3 (9V) battery
into the transmitter (hand set).
3. Feed the cable from the receiver unit
heat shield to the spade terminals on the
control valve, keeping the cable clear of
the underside of the tray. The cable
connectors must be matched to the
appropriately sized spade connector.
4. Position the receiver under the heat
shield as shown in
Figure 47
.
5. Test the operation of the drive motor
using the hand set as per Users
Instructions (
Section 2.1.3 - Lighting
Procedure (Remote Control)-
on page
8
).
6. Proceed to
Section 3.7.5
to commission
the installation.
RECEIVER
UNIT
HEAT
SHIELD
Figure 47
