Page 37
3.7.3. Continuation of Installation - Total Control Model
1. Unpack the box containing the Receiver
and the Hand Set.
2. Fit four AA (1.5V) batteries into the
receiver unit and the PP3 (9V) battery
into the transmitter (hand set).
3. Feed the cables from the valve through
the heat shield and connect to the
receiver as shown in
Figure 49
, keeping
the cables clear of the underside of the
tray. Do not force the valve cable plug
when inserting into the receiver – it only
fits one way.
4. Position the receiver under the heat
shield as shown in
Figure 49.
5. Test the operation of the drive motor
using the hand set as per Users
Instructions (
Section 2.1.5 Lighting
Procedure (Total Control)
on page
10
).
HT
Lead
SW
)
(yellow
TC
(
)
red
Valve
Cable
Figure 49
