Magicard Rio Pro, Maintenance Manual

Page: 47 / 108

Ultra Electronics Card Systems
Rio Pro Maintenance Manual
- 47 -
CAUTION The following procedures involve contact with Electrostatic Sensitive Devices. All precautions for
handling Electrostatic Sensitive Devices should be followed at all times, including the use of a grounded
wrist strap.
Removing & Refitting the LCD Display.
1. Disconnect the electrical connections to the
printer‟s front LCD (Liquid Crystal Display).
2.
LCD is held in position by the plastic catch (arrowed above, right) in the centre of its top edge. Gently push upwards and remove the
LCD from the main print engine.
Refitting is the reverse procedure.
SECTION 11.6 REMOVING & REFITTING OF THE FRONT & REAR CARD SENSOR
SECTION 11.7 REMOVING & REFITTING THE LCD DISPLAY
Removal & Refitting of the Front & Rear Card Sensor
1. Working inside the printing compartment the front and rear Card Sensor plastic clips can be released. The plastic clips are situated adjacent to
the Card path at the front and rear of the printing area.
2.
Withdraw the two plastic clips and Card Sensors from underneath the machine. The Card sensor PCB‟s can now be disconnected from the
wiring.
Refitting is the reverse procedure.
Middle Card Sensor cannot be
removed at this point, refer to
Section 11.16 to remove
Card Sensor locations in the Rio Pro
(Printer viewed from underside)
Front
Mid Front Rear