Magicard Rio Pro, Maintenance Manual

Page: 44 / 108

Ultra Electronics Card Systems
Rio Pro Maintenance Manual
- 44 -
The Magicard Rio Pro and Rio Pro Duo Printers have been designed with a modular construction to make servicing and
repair of the Printer very easy.
The following guidelines show you how to change the middle Card Sensor which is the most difficult component to replace.
All other parts can be exchanged following this procedure.
SECTION 11 DISMANTLING AND ASSEMBLING THE PRINTER
SECTION 11.1 REMOVING & REFITTING THE PRINTER CASING.
SECTION 11.2 REMOVING & REFITTING THE FRONT FASCIA COVER
Removing & Refitting the Printer Casing.
1. Remove the front and rear Hoppers. Remove the Dye-Film.
2.
Working below the Printer, gently move the two front plastic catches outwards in the direction shown above.
3.
You can now lift the front end of the Printer out of the case, tilting it backwards. This will then release the two rear plastic catches and allow the
complete print engine to be removed.
Refitting is the reverse sequence. Locate the connector panel and carefully line up the two rear plastic catches first and lower the print engine into
place.
The front catches will locate and click into place (ensure no wires are trapped).
Removing & Refitting the Front Fascia
1.
Remove the Printer casing as described in Section 11.1.
2.
The front fascia can now be removed by pulling the front fascia away
from the main print assembly. (Take care to retain the white Button
covers).
3.
The two securing plastic catches are inside the area where the
printed Card collector sits.
4.
The LCD display remains attached to the main print assembly.
Refitting is the reverse sequence. Ensure the LCD Display wires are not
trapped between the fascia and print engine.
Refit the Printer casing as described in Section 11.1.