Magicar M880AS, Installation Manual

Page: 42 / 69

44
EN EN
1. Turn the ignition on and open the door.
2. For programming menu No.1 keep buttons
l + ll pressed for 2 seconds.
For programming menu No.2 keep buttons l + lV pressed for 2 seconds.
Siren will beep once to confirm the access of the Programming mode.
3. Within 2 seconds of the step 1 press button IV as many times as is the order number of the
function you want to set. After each pressing of button IV the lights will flash and the siren
will beep.
4. Wait for a few seconds. Siren will beep and the lights will flash as many times as is the
function order number. If the number of flashes is wrong, start the process over.
5. Within 5 seconds after flashing/lightning ends, make your choice:
Press button I to choose option 1. Siren beeps once, lights will flash once.
Press button II to choose option 2. Siren beeps twice, lights will flash twice.
Press button III to choose option 3. Siren beeps 3 times, lights will flash 3 times.
Press button IV to choose option 4. Siren beeps 4 times, lights will flash 4 times
6. The alarm will exit the Programming menu mode.
Note:

If you want to carry out any other changes, start the whole process over again.

If you hear a long beep, you are out of programming menu area. Start again by the step 1.
Failure notice:
If the remote happened to be out of the
range when programming changes, it will display „FAIL“
notice and the programming will be cancelled.
Programming menu No. 1

When the door is open and ignition is on keep buttons I and II pressed simultaneously for 2 sec.
No. Function
Options
Button I Button II Button III Button IV
1-01 TURBO mode Off 1 min. 3 min. 10 min.
1-02 Regular starting Off On - -
1-03 Engine running time 10 min. 15 min. 25 min. 5 min.
1-04 Emergency code RPS Off On - -
1-05
Reservation mode set-up
By closing the
door
By closing the
door and pressing
button l
By closing the
door+turning
alarm on
By closing
the door
without hand
brake
1-06
Flashing when the doors
are open
Off On - -
1-07 Heating time 3 sec. 5 sec. 8 sec. 12 sec.
1-08
Flashing when the hood
is open
Off On - -
1-09 Engine sensing Alternator Revs - -
1-10
PIN code
Off On - -
1-11
Start kill/IG kill
IG kill Start kill - -
1-12
Dome light delay
Off 5 sec. 15 sec. 50 sec.
1-13
Ultrasonic sensor on/off
during remote start
Off On - -
1-14 CAN mode Read only Read and Write
Read, Write and
close windows
-
1-15
Open the Trunk with unlock
and disarm without unlock
and without
disarm
- -
1-16 Automatic rearm On Off - -
1-17 Open trunk cancel
reservation
On Off - -
1-18 Siren output as siren as klaxon - -
1-19 Start procedure standard for START button - -