Magicar M880AS, Installation Manual

Page: 36 / 69

38
EN
I. INTRODUCTION
MAGICAR M880AS is a safety device with the highest level of security. Thanks to the 2-way
remote with pager you will be immediately informed about possible car intrusion, as well as the
manner of the intrusion even though you are too far from the car to hear the siren.
MAGICAR M880AS enables you to remote start your vehicle. You can use it to pre-heat the car
in the winter or cool it down in the summer just before your trip starts. The vehicle is secured even
when the remote start is running and when intruded, the engine will stop and get blocked.
The biggest advance of the two-way remote control is a possibility to use without direct view of
the car. All the commands you will send will be confirmed by remote.
For even higher security level the car alarm is equipped with a two-digit PIN code for entering the
valet mode.
II. PLACING
When fitting each component consider properly the right place for a microwave interior sensor
(if fitted). Since this sensor is working on magnetic principle, it is very sensitive to a magnetic field
developed in car solenoid relays, which may cause a false alarm. For example, when checking a
car status by the remote controller, parking lights will flash. If the sensor is placed too close to the
lights’ relay, it may trigger the alarm. Check this possibility before final fitting of the sensor
Place the
antenna on front or rear window the way that it is not in your view. As an alternative
place you can use the shade on the driver’s side. The antenna is designed for a horizontal use.
Any other positioning may cause decrease of operation range
Glue the round sticker on the
RPS sensor and, after taking the foil off, place the sensor on the
front window on a visible place, not in the driver’s view. As a part of the RPS there is a LED diode
and a button. The RPS sensitivity level is adjustable on its back side by a three-position switch.