12
PRELIMINARY REVIEW
Check for Damage
Make sure that the various parts of the programming tool do not show physical
damage due to impacts, tears or abrasions.
Specifically:
•
that there are no marks or dents, indicative of damage occurred during transport;
•
that the cables and connections are not damaged;
•
that no water, humidity and/or condensation has formed during transport.
It is advised to wait about 30 minutes before carrying out any further operation.
The lighting system (natural and/or artificial) of the configuration area must ensure a
minimum illuminance value of 200 lux.
Damage Reporting Procedure
In the event that damage is found, interrupt the procedure in progress and report the
nature of the damage to the manufacturer’s authorized assistance.
IF USING THE PROGRAMMING TOOL WITH A BENCH TOP POWER SUPPLY, CHECK
THE COMPATIBILITY (SEE TECHNICAL DATA). THE BENCH TOP POWER SUPPLY
MUST BE CONNECTED TO AN ELECTRICAL SYSTEM THAT COMPLIES WITH LEGAL
REQUIREMENTS AND BE EQUIPPED WITH EARTHING AND A CIRCUIT BREAKER
During configuration and the subsequent use of FLEX, incorrect operating conditions
may occur that are not foreseen by this documentation. These completely anomalous
situations may be caused by external factors or by accidental failures not foreseeable
by the manufacturer.
The manual must be stored by the user responsible for managing, maintaining and
using the FLEX programming tool.
2
In the event of damage or loss of the manual, a certified copy may be requested by
the customer from the manufacturer. It is recommended that the user store a copy in
a safe place.
3
1
USE
Summary of Contents for FLEX FLK02 FLX1.1
