Factory Reset
Choosing ‘Yes’ to this option will result in Magic TV™ deleting all channels
and resetting all options to the factory defaults. After this has been performed,
Magic TV™ will start as if for the first time and you will be taken through the
Guided Setup process.
Firmware upgrade
From time to time Magic TV™ will receive updates for the software that controls
it. It is important that your firmware is up-to-date, as new features, bug fixes
and enhanced operation may be available.
Normally these updates will occur automatically Over-The-Air (OTA).
Firmware can also be updated via a USB drive and over the internet.
Upgrading the firmware will not change, reset or delete any current settings.
See section 9.2 for Firmware Upgrade instructions.
Advanced Settings
Sleep Timer
Start-up Timer
Standby Timer
Magic TV™ can be set to Sleep, Standby or
Wake up at a specific time each day
Remote Control Selection
Magic TV Remote
Enable*/Disable
Xbox 360 Remote
Enable/Disable*
MCE Remote
Enable/Disable*
Up to three Magic TV™ units can be used simultaneously in the same room.
This menu is where you tell each unit which remote controls to listen to.
See section 2.1 for full details.
System HDD Idle Standby
On
Off *
When this option is enabled, the system Hard Disk Drive will spin down (reducing
noise and power consumption) after 15 minutes of inactivity. There may be a few
seconds’ delay when the HDD is required again (e.g. for recording or playback).
Standby Mode
Fast Startup *
Energy Saving
All Off
Normal operation. The main CPU runs in
standby mode which enables Magic TV™
to display a picture a few seconds after
powering up
Everything except the Front Panel Display
is turned off in standby mode. It can take
approximately 40 seconds for Magic TV™ to
power up
Everything is turned off during standby.
It can take approximately 40 seconds for
Magic TV™ to power up
Magic TV™ will automatically power up to make a scheduled recording
in all three modes.
72
73
9.1
Network Setup
74
9.2
Firmware Upgrade
75
9
System Operations
8
Magic TV™ Settings
* = default setting
