Maggi 16430201, Original Use And Maintenance Manual

Page: 20 / 56

EMERGENCY PUSHBUTTON
TO HALT THE ENGINE (THE
BUTTON IS NOT AUTOMATI-
CALLY RELEASED)
By pressing this button all electrical functions of the machine
are switched off.
To switch electric functions on, turn the mushroom pushbutton
in the direction indicated by the arrows.
1
PUSH BUTTON TO MAKE EN-
GINE OPERATIONAL; MAIN
SWITCH
1 - It gets the engines ready to be started and hence it gets the
spindles ready to rotate during the working cycle.
It the switch is turned on power is supplied
2
ON/OFF POWER INDICATOR
PILOT LIGHT
1 - If the light is on power is available.
2 – If the light is off power is not available.
3
FEED SPEED ADJUSTMENT
(HEAD 1 and HEAD 2)
1 – It adjusts drills boring feed speed
4
(Head 1)
(Head 2)
16.5 CONTROL PANEL
The control panel is located on the left-hand side of the machine:
16.3 MACHINE STARTING
The operator’s site and the control board are located in the machine electrical control panel. The operator will
position the wood pieces on the working table after having adjusted stops.
15.4 WORKING CYCLE
After having programmed the machine, follow the instructions given in the following paragraph to start the
working cycle:
1) Turn the main switch (2) and set it to position 1. The machine is ready to start the working cycle.
2) Press the pedal (A); the spindles will turn and the head will start the working cycle while the hold down
clamps will clamp the piece.
3) If the pedal is released, the head will return in its initial position and the spindles will stop.
4) Hold down clamps will release the block when the head returns to its initial position.
Should you need to interrupt the working cycle, press the emergency pushbutton (1)
Page
16
4
3 1
2
A