INITIAL SETUP, INSTALLATION, AND ASSEMBLY:
13. STARTUP PROCEDURE
To start up your turntable, verify that all the connections and
adjustments mentioned previously have been done correctly.
Once that is done, follow the next steps.
Switch the power button to the ON position.
Place vinyl on the platter.
The motor is a very low torque motor, and produced very low
vibrations and noise, therefore to start it, spin the platter
clockwise manually a few turns, reaching the desired speed
of 331/3 rpm or 45 rpm and the motor will start and will
continue spinning the platter at the correct speed.
Select the desired RPM by lowering or raising the turntable drive
band from the motor axis. The top grooves on the pulley are for
33 RPM, and the lower grooves are for 45 RPM.
Raise tonearm by the lever, and set to the position where de vinyl
or desired song begins.
Lower tonearm using the tonearm lifter to the desired position on
the record.
Wait for your favorite vinyl or song to start, and enjoy your new T3
turntable.
14. SHUTDOWN PROCEDURE
Raise tonearm with the tonearm lifter.
Place tonearm on the tonearm rest support.
Power OFF the turntable.
Wait for the platter to stop spinning, or stop platter manually.
Remove vinyl from the platter.
15
Summary of Contents for TT10
Page 1: ...TT 10Turntable User Manual...
