9
4.
When done, you can pair the monitor with your device by tapping
Main menu > Settings > Sensors > Heart rate
.
Note: the sensors “sleep” when not in use to conserve battery power.
They “wake up” when they receive their usual input - the Heart Rate
Monitor’s pads must firmly touch your skin to wake up.
The sensor can only be paired within a few minutes of “waking up”, or it
goes back to sleep.
Battery Replacement Information:
The cadence sensor and heart rate monitor each contain a replaceable
CR2032 battery. Follow the instructions below to replace the battery:
1.
Locate the battery cover on the back of the unit, and then twist the
cover counterclockwise (e.g. by using a coin) to remove the cover
and battery.
2.
Insert the new battery into the battery chamber .
3.
Making sure the rubber ring is in place, replace the cover.
4.
Twist the cover clockwise (e.g. by using a coin) to close the cover.
Speed/Cadence Sensor Battery
Heart Rate Monitor Battery
Putting on the heart rate monitor
The heart rate monitor is used for selected models only.
Note:
Please note the heart rate monitor is not a medical device and its readings
are not a substitute for obtaining measurements that require medical precision.
It is strongly recommended to consult a doctor if you have a pacemaker or other
implanted devices before using the heart rate monitor.
1.
Before using the heart rate monitor, wet the contacts on the back of
the chest strap.
Note: Y
ou can also use an electrolyte
gel (usually available in local sports
stores) to ensure good contact.
2.
Adjust the elastic strap so it’s
snug while you are putting it on.
Ensure that you can take a good
deep breath after putting on the
strap.
3.
Follow the instructions below to wrap the strap around your back,
and then secure it on the other side with the buckle.
Note:
Putting on the heart rate monitor is like wearing an elastic belt around
your lower chest.
