macnil GT ALARM GT1006CB, Installation Manual

Page: 41 / 77

ATTENTION:
- Before entering the QUICK TEST function, close and open the vehicle using the original remote
control.
- If you want to test the CAN BUS line first you have to manually or automatically set the CAN
BUS configuration of the vehicle.
When the control LED is switched off, the QUICK TEST can be performed.
Soliciting the various alarm lines, beeps and flashes of the control LED are emitted. The
optical/acoustic signals emitted are summarized in the table below:
Cause of Alarm
No. of LED control
flashes
No. of siren beep (*)
Ultrasound 1 GREEN 1
Additional input from wire 2 GREEN 2
Entrance Doors from wire 3 GREEN 3
Input +15/54 from wire
4 GREEN
4
Input CAN BUS Door Guide 5 GREEN 5
CAN BUS entrance Passenger door 6 GREEN 6
CAN BUS Input Rear Door Guide 7 GREEN 7
CAN BUS entrance Rear door Passenger 8 GREEN 8
CAN BUS input +15/54 9 GREEN 9
CAN BUS entrance Hood 10 GREEN 10
Entrance CAN BUS Trunk 11 GREEN 11
CAN BUS entrance Trunk 2 12 GREEN 12
CAN BUS entrance Trunk 3 13 GREEN 13
Input CAN BUS Auxiliary 14 GREEN 14
CAN BUS input Auxiliary 2 15 GREEN 15
Original remote control closure of the vehicle (only for CAN BUS
vehicles)
1 RED -
Original remote control opening of the vehicle (only for CAN BUS
vehicles)
2/4 RED -
14
En